Mole Excavating can install pipes for Ground source heat exchanger pumps that utilise geothermal energy.

All different methods of installation can be quoted and catered for, from horizontally laid pipes to a new method that is yet to be introduced to the channel islands that needs comparatively little in the way of surface area to work and is also a more efficient system than vertical bores that may not have been drilled deep enough or been thoroughly filled with grout for an efficient heat transfer, the pipes are also seperated so you dont get a mutual influence from other pipes, where they could all be cooling the ground as they are too close together, reducing their efficiency further.

A Geothermal setup that hasnt been drilled deep enough, grouted properly or have enough bores will quickly use up all the heat energy within the drilled area and the customer will see a reduction in heat values within a few years after installation and the initial set up cost/investment would need to be repeated.

Other methods for reducing surface disturbace can also be catered for, horizontal pipes can have a minimal trench cut of only 6" wide to save on ruining a lawn and adding cost for landscapers laying turf and reinstatement.